MaxTronic Orion 410SR Manuel d'utilisateur télécharger pdf (Page 23)

Maxtronic Orion 410SR User Guide

Hardware Installation

10. Now you could push back the front panel door

and locked for next setp.

Do not install the HDD(s) into the Orion 410SR NAS Sys-

tem while it’s powered off under any conditions.

The following are exceptions:

1. The HDD(s) have been initialized by the same Orion 410SR

and have been performing daily routine tasks.

2. Performing “Disk Roaming” procedure to reduce system

down time.

To perform “Disk Roaming“:

a. Power off the old NAS system.

b. Execute Factory Default on the new NAS system and

then power it off.

c. Remove the HDD(s) from the old NAS system.

d. Insert the HDD(s) into the new NAS system. Please be

sure the model and firmware of the new system are the

same as the old one.

e. Power on the new NAS system and Disk roaming is com-

plete.

Hot plugging previously initialized HDD(S) will overwrite existing

user configurations, RAID settings, and any data in the drive.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 103 104

Pas de commentaire

MaxTronic Orion 410SR Manuel d'utilisateur Page 23